Making a difference for our customers
+86 181 0304 3363

Sales Email: sales@thunderlaser.com
Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting

Location:Home >troubleshooting
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


  • Operation manual for Thunder laser machine

    Operation manual for Thunder laser machine

    Release Time:2018/11/16Browsing Times:1638

    Operation manual for Thunder laser machine To be safe, never ever run the laser system unattended. According to international standard,“O”means close;“I”means open for the...

  • How to disassemble your Nova

    How to disassemble your Nova

    Release Time:2018/11/16Browsing Times:1394

    The Users Guide section will walk you through 6 steps for learning how to disassemble your Nova   Note: There’s glass laser tube inside the laser machine, be careful and do not collide with a...

  • USB cable connection

    USB cable connection

    Release Time:2018/11/16Browsing Times:9182

    Test the connection as following:   1. Don’t forget to install the driver for USB. If you are not sure, just install USB driver again. 2. Laser cutter system connect to the PC. If still ...

  • How to setup wireless network connection for Thunder laser machine

    How to setup wireless network connection for Thunder laser machine

    Release Time:2018/11/16Browsing Times:3479

    Here’s what you’ll need: ● A computer with wireless capability; Almost all laptops have wireless capability built-in, but most desktop computers do not have wireless built-in. ● A wirel...

  • How to run several laser machines with one  PC via Ethernet cable

    How to run several laser machines with one PC via Ethernet cable

    Release Time:2018/11/16Browsing Times:1701

    If there is an Ethernet hub in your network, it’s able for one PC (laser software) to connect with several machines. But pc will does only communicate with one machine and sending the file in...

  • Ethernet  cable connection

    Ethernet cable connection

    Release Time:2018/11/16Browsing Times:3918

    Connect the laser cutter system to desktop or laptop via an Ethernet cable. 1. Configure computer Go to Start>>Control Panel>>Network and Sharing Center, configure the connection for lo...

  • Maintenance manual for Thunder laser system

    Maintenance manual for Thunder laser system

    Release Time:2017/06/26Browsing Times:6495

    Proper care and routine maintenance of the machine will ensure optimal performance over a long service life. DAILY CHECK LIST ☑ Focus lens WEEKLY CHECK LIST ☑ Reflector ☑ Laser combiner ☑ Keep mach...

  • How do I replace the drive shaft module?

    How do I replace the drive shaft module?

    Release Time:2017/03/22Browsing Times:2803

    Firstly, disconnect the machine from its power source Disassembly procedure: Prepare M3/M4/M5 Allen Wrench Tips:Loosen in anticlockwise, tighten in clockwise. 1. Loosen two upper screws on the buc...