Making a difference for our customers
+86 181 0304 3363

Sales Email: sales@thunderlaser.com
Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting

Location:Home >troubleshooting
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


  • How do i replace the controller board

    How do i replace the controller board

    Release Time:2018/11/23Browsing Times:2938

    Firstly, turn off the whole machine power. Remove Old Part: Open the lower right hand door panel, find the main controller board, like below. Unplug all connectors on the controller board, then rem...

  • Chiller alarms unusually

    Chiller alarms unusually

    Release Time:2018/11/17Browsing Times:3057

    Chiller lcd panel is showing normal, but the red light on and buzzer beeping. Here are the reasons: ● Water is not enough Please check the water level of chiller, like below: Keep the water level i...

  • Air pump won’t work or no air  assist when job starts

    Air pump won’t work or no air assist when job starts

    Release Time:2018/11/17Browsing Times:3136

    Here are the reasons: ● Air compressor break down How to check if air compressor break down, there’s a common way to connect it to the power directly using the power cable of chiller, then ch...

  • Exhaust fan cannot extract smoke  or dust

    Exhaust fan cannot extract smoke or dust

    Release Time:2018/11/17Browsing Times:2798

    Here are the reasons: ● Exhaust fan break down How to check if exhaust fan break down, there’s a common way to connect it to the power directly using the power cable of chiller, then check if...

  • How to prepare your files for  feeding into the laser program to cut

    How to prepare your files for feeding into the laser program to cut

    Release Time:2018/11/17Browsing Times:2733

    Scenario 1: If the vector has overlapped paths and it will be cut repeatedly. Solution: In RDworks, you can use “Delete overlap” tool to delete all overlapped paths, like below.  ...

  • How to prepare your files for  feeding into the laser program to engrave

    How to prepare your files for feeding into the laser program to engrave

    Release Time:2018/11/17Browsing Times:4767

    Note: the laser machine can only burn into or through material. Also, the beam can only be made to follow straight or curved paths or to burn a grid of dots (a bitmap image). There is no way for th...

  • Cutting problem– Some point of the same piece  of materials cannot be cut through

    Cutting problem– Some point of the same piece of materials cannot be cut through

    Release Time:2018/11/17Browsing Times:2103

    Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large cutting graphic. Please fix ...

  • Engraving problem—how to Improve Engraving Quality in the  scan mode of X-swing

    Engraving problem—how to Improve Engraving Quality in the scan mode of X-swing

    Release Time:2018/11/17Browsing Times:8864

    The engraving quality working on x-swing is generally worse than x-unilateralism, it usually results in ghosting effect or image offset or bi-directional engraving offset, like below. In RDworks, y...