Making a difference for our customers

Sales Email: sales@thunderlaser.com
 Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting
Location:Home > troubleshooting > laser cutter software > Why does the graphic size that imported to RDWorks different from its original size
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


Why does the graphic size that imported to RDWorks different from its original size

Release Time:2016/11/21 laser cutter software Browsing Times:2833

If the file being imported is DXF format, the problem may be caused by improper software setting.

For example, the unit of the original DXF file is “inch”, but in RDWorks, the DXF unit is set as “mm”. When you import the DXF graphic to RDWorks, the graphic will be read as “mm” unit.

Therefore the size turn out in RDWorks is different from the original size.

Please refer to below photo to set DXF unit in RDWorks:



Please make sure DXF file unit from your drawing software is the same as RDWorks’ s DXF unit.