Making a difference for our customers

Sales Email: sales@thunderlaser.com
 Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting
Location:Home > troubleshooting > laser cutter software > Why does the cutting and engraving graphics reverse (mirror)
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


Why does the cutting and engraving graphics reverse (mirror)

Release Time:2016/11/23 laser cutter software Browsing Times:7297

This problem may cause from improper setting of the software.

Please start up the laser software RDWorksV8. And then click “Config” – “system setting” on the menu bar. This dialog box appears.



Make sure “Axis X mirror” is unticked, and “Axis Y Mirror” is must ticked.

If your setting is different from this, this is the problem why your cutting/engraving reverse. Just reset the config as above.