LASER SETTINGS FOR CUTTING, ENGRAVING AND MARKING
Explore recommended CO₂, fiber, MOPA, and UV laser settings. Compare power, speed, frequency, DPI, focus, and material parameters for cutting, engraving, and marking.
WHAT ARE YOU LOOKING FOR?
Search Across Products, Blog Posts, Support Content, And Resources.
Thunder Laser Settings
These settings are for reference only. Actual results vary by material source and machine — always run a test on scrap first.
| Laser Power | Material | Machine Model | Processing | Speed (mm/s) | Power (%) | Pulse Width (ns) | Frequency (kHz) | LPI (DPI) | Processing Times |
LASER SETTINGS FAQS
These settings are starting references for the Thunder Laser machines and configurations listed in each row. Another machine may respond differently even if its rated wattage is the same, because the laser source, optics, controller, and other setup details can vary. Use the values to plan a small test rather than copying them directly into a different machine.
First confirm the material’s composition, coating, and thickness so you know which process is suitable. A similar material in the table may help you choose an initial test range, but it cannot guarantee the same result. If you cannot identify a reliable starting point, you can send Thunder Laser the material details and desired result for application testing.
They can be useful for comparison, but they are not a direct substitute for settings recorded on your machine. Match the listed model and laser power whenever possible. If you need to start from another model’s row, test the result on a small piece and adjust it for your own setup before processing the full job.
Two sheets or parts sold under the same material name may differ in composition, thickness, coating, density, or surface finish. Focus, optics, gas or air supply, and machine condition can also affect the result. Test a piece from the batch you will actually use, especially when you change suppliers or need a consistent production finish.
The table gives you a practical starting point, not a guaranteed final recipe. Before a full run, check that the test result meets your requirements for cut quality, marking contrast, engraving depth, appearance, and consistency—whichever apply to your project. Save the verified settings together with the material and machine details so you can reproduce the result.
Start with a table row that closely matches your machine, material, and processing goal. Run a small test, compare the results, then narrow the settings around the most promising result and verify it on a representative design or part. For a step-by-step walkthrough using CO₂ cutting and engraving examples, see Find the Best Laser Material Settings. Other processes should be tested using the parameters relevant to their own machines.
Tell us the material type, thickness or surface finish, and the result you want to achieve. If you already have a machine, include its model and laser power; if you are choosing one, describe the part and expected workload instead. Photos, drawings, or a physical sample can help the application team understand what a successful result should look like.
Need Settings for Your Material?
The settings above are a starting point. Tell us your material, machine, and desired result. Our application team can test your sample and recommend a suitable setup.


