Start by peeling off the protective film from the top surface of the acrylic sheet—the side that faces the laser. This prevents burn marks or smoke stains from forming on the visible surface during cutting.

You can leave the bottom film on to protect the underside while it rests on the workbed. Once ready, place the acrylic flat on the laser cutter’s bed and secure it with pins or magnets.

Open your preferred laser software, such as LaserMaker, and import the design file. Adjust the size and layout as needed, making sure the designs are evenly spaced to make the most of your acrylic sheet.

For the laser cutting layers, pay extra attention to the minimum power setting. If the min power is too low, the corners may not cut through; if the min power is too high, the corners may not look clean.

Accurate focusing is critical for achieving smooth, clean cuts on acrylic. If your machine has auto focus, use it for quick setup. For manual focusing, lower the laser head with the focus stick until it touches the acrylic surface at the correct angle.

Before starting the job, run the frame function, also called border, in your software. The laser head will trace the outline of the design with a visible guide light. This helps confirm that the design fits within your acrylic sheet and avoids wasting material.

Once everything is adjusted, start the job and monitor the process as it runs. Watch for excessive smoke, movement of the acrylic sheet, or any warning alarms, and never leave the laser unattended while it’s operating.

Once the cutting is complete, remove the hanger from the bed. If the back side’s protective film is still on, peel it off to reveal the glossy, festive finish.

Check the edges and surface, then clean away any dust or residue. Your adorable Christmas acrylic hanger is now ready to use or gift.