Laser Cutting-Acrylic Umbrella Stand

Introduction

Does your umbrella leave wet trails on the floor after rainy days? You may need an umbrella stand to solve this issue. We’ve crafted a unique stand using durable acrylic material. Not only did we laser cut an umbrella silhouette design, but we also perforated multiple small holes near the base to aid in water evaporation.

Machine Used

Nova 35 80w

See more details about this machine→

Material Needed

A white acrylic sheet
A tube of glue

Settings

Cutting Speed:10mm/s
Cutting Power:80%
DPI:300DPI

Step 1

Import the file into LightBurn, adjust the size, position, and settings. Check out to ensure everything is in order.

Step 2

Once everything is set, click ‘Print’ to initiate your laser machine’s operation.

Step 3

After all components are cut, apply glue to the joints of the components.

Step 4

Glue and assemble the components together, and it’s finished.

Come and Try!

Picture placing your dripping wet umbrella into this stylish custom stand after returning home. The large negative space cut-out allows excess water to immediately drain through to the bottom reservoir. As it dries over time, the tiny laser-etched holes vent built-up moisture and dampness to prevent musty odors or mold growth.

More than just functional, the striking umbrella outline gives this stand a decorative aesthetic. The precise laser cutting creates clean finished edges that make the acrylic design pop. Use it as a sculptural accent piece even when not holding umbrellas!