Making a difference for our customers
+86 181 0304 3363


Sales Email: sales@thunderlaser.com
Tech Email: tech@thunderlaser.com

laser cutter software software-problem

Location:Home >troubleshooting >laser cutter software
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


  • Why does the cutting and engraving graphics reverse (mirror)

    Why does the cutting and engraving graphics reverse (mirror)

    Release Time:2016/11/23Browsing Times:14851

    This problem may cause from improper setting of the software. Please start up the laser software RDWorksV8. And then click “Config” – “system setting” on the menu bar. This dialog box appears. Make...

  • Why does the graphic size that imported to RDWorks different from its original size

    Why does the graphic size that imported to RDWorks different from its original size

    Release Time:2016/11/21Browsing Times:5366

    If the file being imported is DXF format, the problem may be caused by improper software setting. For example, the unit of the original DXF file is “inch”, but in RDWorks, the DXF unit is set as “m...

  • How to run several laser machines with one PC via USB cable

    How to run several laser machines with one PC via USB cable

    Release Time:2016/11/17Browsing Times:4728

    If there are several USB interfaces with your PC, it’s able for one PC (laser software) to connect with several machines. But pc will does only communicate with one machine and sending the fi...

  • How to install the CorelDraw plugin for RDWorks

    How to install the CorelDraw plugin for RDWorks

    Release Time:2016/11/11Browsing Times:31784

    1. Firstly run CorelDraw and set the parameter following below instructions: 2. After that, close CorelDraw. Double click to open RDWorks installation program. Choose the type of CorelDraw_Laser (b...

  • How to import PDF files into RDWorks

    How to import PDF files into RDWorks

    Release Time:2016/11/10Browsing Times:10637

    1. RDWorks cannot read PDF and open it directly. 2. Use CorelDraw to open/import PDF file. Then save the graphic as DXF file. Like below: 3. Then RDWorks can read the DXF file, Just import the DXF ...

  • Wrong proportions from RDWorks

    Wrong proportions from RDWorks

    Release Time:2016/07/06Browsing Times:4229

    I’d like to cut a Rectangle at 30x30mm, however, it become 30×60.2 in simulation and in laser, Please make sure “Enable rotate engrave” is not ticked. Popular Pages Click to ...

  • Laser cutter has a wrong cutting/engraving size

    Laser cutter has a wrong cutting/engraving size

    Release Time:2016/05/19Browsing Times:13621

    If this problem occurs, generally the pulse setting of the X/Y axis motors is wrong. Please follow the below steps to solve the problem Please draw a 100x100mm square using the cut mode and send to...