-
Why your U-disk can’t be recognized by the machine
Release Time:2020/12/15Browsing Times:377
● Which kind of U disk can be recognized by the machine: Disk capacity:16G(including 16G and below) The U-disk is 2.0 Note: How do you know the U –disk is 2.0 or not. ①USB slot which contains b...
-
Why the “Origin” button of LCD panel not working
Release Time:2018/11/23Browsing Times:4422
Here are the reasons: ● The starting point is set to absolute coordinate in software. Locate on the bottom left corner, the option of “Position” please select to Current position. ● Ori...
-
How to prepare your files for feeding into the laser program to cut
Release Time:2018/11/17Browsing Times:3432
Scenario 1: If the vector has overlapped paths and it will be cut repeatedly. Solution: In RDworks, you can use “Delete overlap” tool to delete all overlapped paths, like below. ...
-
How to prepare your files for feeding into the laser program to engrave
Release Time:2018/11/17Browsing Times:6244
Note: the laser machine can only burn into or through material. Also, the beam can only be made to follow straight or curved paths or to burn a grid of dots (a bitmap image). There is no way for th...
-
Engraving problem—how to Improve Engraving Quality in the scan mode of X-swing
Release Time:2018/11/17Browsing Times:11818
The engraving quality working on x-swing is generally worse than x-unilateralism, it usually results in ghosting effect or image offset or bi-directional engraving offset, like below. In RDworks, y...
-
USB cable connection
Release Time:2018/11/16Browsing Times:12738
Test the connection as following: 1. Don’t forget to install the driver for USB. If you are not sure, just install USB driver again. 2. Laser cutter system connect to the PC. If still ...
-
How to setup wireless network connection for Thunder laser machine
Release Time:2018/11/16Browsing Times:4959
Here’s what you’ll need: ● A computer with wireless capability; Almost all laptops have wireless capability built-in, but most desktop computers do not have wireless built-in. ● A wirel...
-
How to run several laser machines with one PC via Ethernet cable
Release Time:2018/11/16Browsing Times:2414
If there is an Ethernet hub in your network, it’s able for one PC (laser software) to connect with several machines. But pc will does only communicate with one machine and sending the file in...