Making a difference for our customers
+86 181 0304 3363

Sales Email: sales@thunderlaser.com
Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting

Location:Home >troubleshooting
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


  • Why noisy while moving laser head front and back, how to adjust?

    Why noisy while moving laser head front and back, how to adjust?

    Release Time:2017/01/12Browsing Times:5637

    When you move laser head front and back, two couplings make a lot of noise. What is the cause of this? Both sides of transmission shaft are not aligned

  • The machine won’t turn on

    The machine won’t turn on

    Release Time:2017/01/11Browsing Times:8530

    Here are the reasons: ● Emergency Stop key is pressed If it’s pressed, please reset it, like below. ● The circuit breaker has tripped Locate on the lower right hand door panel (or back side door pa...

  • How to replace laser tube?

    How to replace laser tube?

    Release Time:2017/01/07Browsing Times:4207

    Firstly, turn off the whole machine power. Remove Old Part: 1. Unplug the wire between laser tube and laser power supply and take out from the hole, like below. 2.unfix the tube. ① Cut the white ri...

  • How to Replace the rollers and adjust the X Axis Shaft?

    How to Replace the rollers and adjust the X Axis Shaft?

    Release Time:2017/01/05Browsing Times:3508

    1.Please check before adjustment ①Hold and shake it to check if it becomes loose.(Can’t be wobble obviously) ②. In the back of X Axis Shaft have four rollers,both of them should locate on the rail....

  • How to judge if the power of laser tube become weak

    How to judge if the power of laser tube become weak

    Release Time:2016/12/21Browsing Times:3960

    Please find a piece of 6mm acrylic (50*50mm),which used for testing the power of laser tube. Like below.

  • How to adjust the verticality between the X and Y Axis?

    How to adjust the verticality between the X and Y Axis?

    Release Time:2016/12/16Browsing Times:3688

    There are two solutions: 1.Unfix the X Axis. Turn off the whole machine power. There are four screws for each side,loosen them then you can fine tuning the angle of the X Axis. Shown as bellow. D...

  • How to adjust and replace the motor?

    How to adjust and replace the motor?

    Release Time:2016/12/13Browsing Times:3884

    Firstly, disconnect the machine from its power source. ① X-axis Motor Screw A: There are four screws A, for fixing the X motor; Screw B: It’s for adjusting the belt tension, please loosen the four ...

  • How to calibrate the working table to level.

    How to calibrate the working table to level.

    Release Time:2016/12/07Browsing Times:5287

    There are three cases. 1. Two sides of the working table are not of the same height. Turn off the whole machine power, manually pull one of the belts of Z axis so as to adjust the up and down of th...