Making a difference for our customers
+86 181 0304 3363

Sales Email: sales@thunderlaser.com
Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting

Location:Home >troubleshooting
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


  • Engraving problem—the engraving quality is very poor

    Engraving problem—the engraving quality is very poor

    Release Time:2018/11/17Browsing Times:1423

    Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large engraving graphic. Please fi...

  • The laser tube won’t fire the beam

    The laser tube won’t fire the beam

    Release Time:2018/11/17Browsing Times:2438

    Here are the reasons: ● The laser switch is off Please make sure laser switch is on, then open lower left hand door panel (or back side door panel), check if the laser power supply is showing sign ...

  • X-axis not moving at all

    X-axis not moving at all

    Release Time:2018/11/17Browsing Times:2336

    Here are the reasons: ● X-axis limit switch problem Locate on the left side of x-axis, please check if the wiring and roller lever of switch are well or not, like below. If they both seem to be wel...

  • Y-axis not moving at all

    Y-axis not moving at all

    Release Time:2018/11/17Browsing Times:2465

    Here are the reasons: ● Rotary switch is turned on Note: The rotary-axis and y-axis can be switched, if the rotary switch is turned on, y-axis will not moving at all, and the rotary-axis will need ...

  • Alarm message of LCD panel—Water error

    Alarm message of LCD panel—Water error

    Release Time:2018/11/17Browsing Times:3063

    LCD panel shows the following information: Here are the reasons: ● Water chiller(water pump)is not turned on Please turn on the water chiller before power on the machine, like below. ● Signal cab...

  • Alarm message of LCD panel—No enough extend space

    Alarm message of LCD panel—No enough extend space

    Release Time:2018/11/17Browsing Times:5308

    LCD panel shows the following information: This problem only appears on engraving mode, it’s caused by the buffer distance is out of bound. For example, if you want to engrave a picture of 20...

  • Alarm message of LCD panel—Frame/X/Y Slop  over

    Alarm message of LCD panel—Frame/X/Y Slop over

    Release Time:2018/11/17Browsing Times:3630

    LCD panel shows the following information: Here are the reasons: ● The size of the graphic is larger than the working area of the machine If your laser cutter’s working area is 600×400mm, but...

  • User manual for LCD control panel

    User manual for LCD control panel

    Release Time:2018/11/16Browsing Times:1117

    Contents 1 Function of the Buttons……………………………………2 2 The main interface……………………………………4  2.1 Speed Key……………………………………5  2.2 Max Power Keys……………………………………5  2.3 Set the Layer Parameters……...