Making a difference for our customers

Sales Email: sales@thunderlaser.com
 Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting
Location:Home > troubleshooting > System maintenance and replacement > Maintenance manual for Thunder laser system
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


Maintenance manual for Thunder laser system

Release Time:2017/06/26 System maintenance and replacement Browsing Times:2824

图标1Proper care and routine maintenance of the machine will ensure optimal performance over a long service life.



DAILY CHECK LIST

☑ Focus lens

WEEKLY CHECK LIST

☑ Reflector
☑ Laser combiner
☑ Keep machine clean

MONTHLY CHECK LIST


☑ Rails and Screws
☑ Laser beam path
☑ Exhaust fan
☑ Water Chiller


● DAILY CHECK LIST

• Focus lens
1.Remove the laser head                2. Divide the laser head
focuslen1 focuslen2
3. Remove the focus lens with the tool           4. Clean the lens with lens cloth
focuslen3 focuslen4

Note: The direction of focus lens mounting please refer to below picture:



● WEEKLY CHECK LIST

• Reflector
Use a lens cloth and lens cleaner to keep all mirrors clean
mirror1
mirror2
mirror3



• Laser beam combiner
Use a lens cloth and lens cleaner to keep combiner lens clean.



• Keep machine clean
Remove these small pieces that fall into the honeycomb table and collected in the machine using small brush or vacuum cleaner.



● MONTHLY CHECK LIST

• Rails and Screws
Add lubricant oil (or Rust Preventative Grease) to all rails on X&Y axis.
rail1 rail2


rail3

Add lubricant oil (or Rust Preventative Grease) to four Z axis screws
screws1 screws2



• Laser path
1. Mirror alignment;
When the laser head move to four corners of the working table, please check if the laser beam lasers to the same position on the third reflective mirror.
laser1
2. Vertical alignment;
When the laser head moves to four corners of the working table, please check if the laser beam can vertically go through the 10mm acrylic.
laser2


Please check laser beam path according to the video below.

http://www.thunderlaser.com/how-to-use-your-laser-machine/how-to-adjust-the-laser-beam-path.html


• Exhaust fan
Clean the air intake
fan


• Water chiller
Change the pure (distilled) water and clean the filters;
Note: if water drains slowly from drainage nozzle during water changing, please open the water supply inlet.


More detail please refer to the Chapter 5 Maintenance of User’s Manual.


End