Making a difference for our customers

Sales Email: sales@thunderlaser.com
 Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting
Location:Home > troubleshooting > laser cutter machine > Engraving problem—the engraving quality is very poor
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


Engraving problem—the engraving quality is very poor

Release Time:2018/11/17 laser cutter machine Browsing Times:46

Here are the reasons:

● The needed focus is lost


The bending of the material or the uneven working table can result in different focal lengths, especially for the large engraving graphic.
Please fix the material with magnet and check if the working table are the same height, then calibrate according to the link below.
http://www.thunderlaser.com/troubleshooting/how-to-calibrate-the-working-table-to-level.html


● The focus lens and reflective mirror are dirty

 


● The laser beam path is not aligned

1. Mirror alignment;
When the laser head move to four corners of the working table, check if the laser beam lasers to the same position on the third reflective mirror.

2. Vertical alignment;
When the laser head moves to four corners of the working table, check if the laser beam can vertically go through the 10mm acrylic.

Please check laser beam path according to the video below.
http://www.thunderlaser.com/how-to-use-your-laser-machine/how-to-adjust-the-laser-beam-path.html


End.