Alarm message of LCD panel—Water error
Release Time：2018/11/17 laser cutter machine Browsing Times：191
LCD panel shows the following information:
Here are the reasons:
● Water chiller（water pump）is not turned on
Please turn on the water chiller before power on the machine, like below.
● Signal cable for water protection has no connection
Please has signal cable connected, like below.
● Wiring problem
Please check it according to the video below.https://www.youtube.com/watch?v=zPV8moEZNh8
- Alarm message of LCD panel—No enough exten...
- Why the red dot pointer not being able to ...
- Chiller alarms unusually
- The machine won’t turn on
- Engraving problem—the engraving quality is...
- Alarm message of LCD panel—Machine protected
- Cutting problem– Some point of the s...
- Cutting problem– Why the starting po...