Making a difference for our customers

Sales Email: sales@thunderlaser.com
 Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting
Location:Home > troubleshooting > laser cutter machine > Air pump won’t work or no air assist when job starts
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


Air pump won’t work or no air assist when job starts

Release Time:2018/11/17 laser cutter machine Browsing Times:85

Here are the reasons:


● Air compressor break down

How to check if air compressor break down, there’s a common way to connect it to the power directly using the power cable of chiller, then check if air compressor can be turn on normally, like below:

● Wrong setting

The air assist can be controlled by the layer parameter of software, please make sure you have “If Blowing” selected to YES, like below:


Note: If the Processing Mode is Cut, “If Blowing: Yes” must not be changed.

● The air valve is close

Make sure have the manual air valve opened(horizontal means open), like below:

http://www.thunderlaser.com/how-to-use-your-laser-machine/how-to-use-the-air-valve.html


End.