Making a difference for our customers

Sales Email: sales@thunderlaser.com
 Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting
Location:Home > troubleshooting > How to adjust the verticality between the X and Y Axis?
Image-1

Thunder Laser Video


How to choose a reliable laser cutter

WATCH NOW
▷ How to choose a reliable laser cutter
Image-1

Thunder Laser Video


How to install HR head

WATCH NOW
▷ How to install HR head

How to adjust the verticality between the X and Y Axis?

Release Time:2016/12/16 troubleshooting Browsing Times:913

There are two solutions:

1.Unfix the X Axis.

Turn off the whole machine power. There are four screws for each side,loosen them then you can fine tuning the angle of the X Axis. Shown as bellow.



Diagonal line 1 = Diagonal line 2.

Error value must be less than 0.5mm like below:



① If the Diagonal line 1 > Diagonal line 2.

Please adjust as follow:



② If the Diagonal line 1 < Diagonal line 2.

Please adjust as follow:



Above are just fine tuning the angle of the X Axis, if the error still more than 0.5mm, please further to the solution 2.

2.Unfix the X Axis and coupler

Unfix the X Axis then loose one of the coupler ensure each sides can move separately.



Measure by ruler, make sure they are the same distance as follow:



Then tighten the screws for each side of X Axis firstly, please do it carefully by tighten slowly to ensure the angle of X Axis doesn’t change. After fix them then measure the distance again, ok, then fix the rest of the screws. It’s ok if the error within 0.5mm. finally, fasten the screws of the coupler.