Making a difference for our customers

Sales Email: sales@thunderlaser.com
 Tech Email: tech@thunderlaser.com

troubleshooting troubleshooting
Location:Home > troubleshooting > How do I replace the drive shaft module?
Image-1

Thunder Laser Video


How to choose a reliable laser cutter

WATCH NOW
▷ How to choose a reliable laser cutter
Image-1

Thunder Laser Video


How to install HR head

WATCH NOW
▷ How to install HR head

How do I replace the drive shaft module?

Release Time:2017/03/22 troubleshooting Browsing Times:150

The first step is turn off the whole power.

Remove:



Prepare M3/M4/M5 Allen Wrench

Tips:Loosen in anticlockwise, tighten in clockwise.

1. Loosen two upper screws on the buckle then take out the belt;

2. Unscrew and remove four screws from the blue base;

3. Unfix two screws on coupling

After that, please remove this drive shaft, like below.



Assemble:

Tips: put four screws into the blue base firstly and also the belt, like below.



1. Insert the shaft into coupling then fix the blue base with four screws;

2. Slide the coupling to proper position as the right sides shown, then fix it.



3. fix the belt, like below.



After that, check and adjust the tension of belt, just refer to the belt of right sides.



①Fix the belt

②Adjust the tension of belt

Please note: please don’t forget to fix the nuts after adjusting belt.